Table of Contents
Advertisement
Getting Started
TX (Transmit)
Blinks when the LAN2(WAN) port transmits data.
Col (Collision)
ON when there are collisions occurring on the LAN2(WAN) port.
Rear Panel Description
The Vigor2200 has a reset button, a power jack, and five RJ-45
ports on the rear panel:
PWR
Only the DrayTek supplied power adapter should be connected to
the power jack.
Reset
For firmware upgrades: Press and hold the button, then power ON.
The ACT and LNK LEDs will blink simultaneously (see section 7.5).
To restore default settings: While the device is running, press the
button and hold for more than five seconds. When the ACT LED
begins to blink rapidly, release the Reset button. The router will
restart with the default configuration.
LAN2 ... WAN
These ports are the same Ethernet port with a mutual crossover.
Normally, the DSL/Cable modem should be connected to the WAN
port.
LAN1 ... Uplink
These ports are the same Ethernet port with a mutual crossover.
Normally, you should connect your PC to the LAN1 port and an Ethernet
switch/hub to the Uplink port.
ISDN
Connects to a NT1 box provided by your ISDN service provider.
1-7
Advertisement
Table of Contents
