Table of Contents
Advertisement
Installation & Setup
2.1 Before You Begin
1. Use only the power adapter supplied by DrayTek Corp. Using an
incorrectly rated power adapter will result in damage to the router.
2. Know the type of interface provided by your ISP or telcom. The
standard model only supports the ISDN BRI S/T-interface. If you are
an ISDN U-interface user, you need to order a U-interface model. If
you are an ISDN S/T-interface user, you should have an NT-1 or NT-1
plus provided by your ISP or telcom. Also, make sure an ISDN line is
available (only applies to the Vigor2200 and Vigor2200X).
3. In case of emergency, unplug the power adapter first.
4. Locate the device in a clean location. Do not block the ventilation
slots on the rear panel.
5. Cables must be attached to the correct ports; to do otherwise may
result in damage to the router. Keep cables away from walkways.
6. If you are an S/T-interface user, don't extend the ISDN line greater
than 100 meters from the NT-1 (NT-1 plus) box and the router (only for
Vigor2200 and Vigor2200X).
7. If you are a DSL/Cable user, check that your DSL/Cable modem
supports the Ethernet interface for connecting to your PC. If not, you
will be unable to connect it to the router.
8. Before you set up the router, you need to know the router's default
settings as shown on the next page:
2-2
Advertisement
Table of Contents
