Table of Contents
Advertisement
Getting Started
Reset
For upgrading the firmware: Press the button and hold, then power
ON. The ACT and LNK LEDs will blink simultaneously (see section
7.5).
To restore default settings: While the device is running, press the
button and hold for more than five seconds. When the ACT LED be-
gins to blink rapidly, release the Reset button. The router will restart
with the default configuration.
Uplink ... P4
These ports are the same Ethernet port with a mutual crossover. Nor-
mally, the Uplink port should be connected to an external Ethernet
switch/hub, the P4 port should be connected to your PC.
P3, P2, P1
These switch ports should be connected to your local PCs.
WAN LED
ON when the DSL/Cable modem is connected.
Blinking when data packets pass through the port.
WAN
This port should be connected to the Ethernet port of an external
DSL/Cable modem.
ISDN
Connects to an NT1 box provided by your ISDN service provider.
1-10
Advertisement
Table of Contents
Need help?
Do you have a question about the Vigor2200 Series and is the answer not in the manual?