5.5 Static Route Setup
Vigor2200 series routers can also be set to operate as pure IP rout-
ers. You should specify the IP network configuration for the LAN1
interface using the 2nd IP address and 2nd subnet mask fields on the
"LAN1 TCP/IP and DHCP Setup" page, and for the LAN2 interface
using "Internet Access Setup" > "Static or Dynamic IP" (See Chap-
ter 3.2 Internet Access Setup).
Note:
The Vigor2200 series routers have RIP (Routing Informa-
tion Protocol) built-in by default. If the remote routers
have the same protocol, the RIP will be used for exchang-
ing routing information. Here, the Static Route Setup
just provides a way to guide specified IP packets through
specified routers statically.
In this application, you may want to assign static routing rules for
LAN1 or LAN2. Static Route Setup provides this function. The
Advanced Setup
5-9