Table of Contents
Advertisement
Old Password:
If this is the first time to set a password, leave this field blank.
New Password:
Enter an administrator password.
Retype New Password:
Type the password again for confirmation.
Click "OK".
3.1.2 Configuring LAN 1 IP Address and DHCP Server
Each of the Vigor2200 series routers has two Ethernet interfaces, one
is for connecting to local network users, the other is for connecting to
an external broadband device (i.e. DSL modem/router or Cable mo-
dem). The LAN1 port is connected to the local Ethernet network.
LAN 2 (WAN) is connected to the external broadband device.
There are two sets of IP address settings for the LAN 1 interface. The
1st IP address/netmask is for private users or NAT users, and the 2nd
IP address/netmask is for public users. To allow public users re-
quires you to have subscribed to a globally reachable subnet from
your ISP.
For example, for some ISDN accounts, the ISP will assign a few pub-
lic IP addresses for your local network usage. You could use one IP
address for your router, the 2nd IP address/netmask should be
configured using the public IP address. Other local PCs should set
the router IP address as the default gateway. When the ISDN con-
nection to the ISP has been established, each local PC will directly
route to the Internet. Also, you could use the 1st IP address/netmask
to connect to other private users (PCs). These users' IP addresses
will be translated to the 2nd IP address by the router and sent out via
ISDN.
Basic Setup & Internet Access
3-3
Advertisement
Table of Contents
