Table of Contents
Advertisement
System Management
Drop B1: Click to disconnect the B1 channel.
Drop B2: Click to disconnect the B2 channel.
LAN1 Status:
IP Address: IP address of the LAN1 interface.
TX Packets: Total number of transmitted IP packets sent since
the router was powered on.
RX Packets: Total number of received IP packets received since
the router was powered on.
LAN2/WAN Status:
Mode: Indicates which broadband access mode is active.
Depending upon the broadband access mode, you may see
Static IP, Dynamic IP, PPTP, or PPPoE.
GW IP Addr: Indicates the gateway IP address.
IP Address: IP address of the LAN2/WAN interface.
TX Packets: Total number of transmitted IP packets sent dur-
ing this connection session.
TX Rate: Transmission rate for outgoing data. The unit is char-
acters per second (cps).
RX Packets: Total number of received IP packets received dur-
ing this connection session.
RX Rate: Reception rate for incoming data. The unit is charac-
ters per second (cps).
Up Time: Connection time. The format is HH:MM:SS where
HH means hours, MM means minutes, and SS means sec-
onds.
Drop PPPoE or PPTP: Click the link to disconnect the PPPoE
or PPTP connection.
7-4
Advertisement
Table of Contents
