Table of Contents
Advertisement
Getting Started
Note:
On some NT-1 boxes, the ISDN LNK LED will go OFF
when the ISDN line has been idle for a while. When the
router is dialling or answering a call, it should be ON
again.
B1
ON when there is a successful remote connection on the ISDN BRI
B1 channel.
B2
ON when there is a successful remote connection on the ISDN BRI
B2 channel.
LAN1 Group:
LNK (Link)
ON when the connected network card or hub has linked up.
Blinking when Ethernet packets pass through the interface.
100M
ON when the connected network card or hub support 100Mbps Fast
Ethernet.
FDX (Full-Duplex)
ON when the connected network card or hub supports full-duplex trans-
mission mode.
LAN2 Group:
Broadband
ON when broadband access is active.
LNK (Link)
ON when the connected network card or hub is connected.
Blinking when the LAN2(WAN) port receives packets.
1-6
Advertisement
Table of Contents
