Table of Contents
Advertisement
Advanced Setup
addition, we assume another router, 192.168.200.253/24, is also con-
nected to the same Ethernet segment as LAN2(WAN). Behind the
router is another IP network, 192.168.202.0/24. The following sub-
sections based on this example give more detailed explanations.
5.5.1 Add a Static Route
In the above example, if you want the 192.168.202.0/24 and
192.168.100.0/24 network to have access to each other, you should
add a static route in the Vigor2200 router and also in the
192.168.200.253 IP Router. The following setting show the Vigor2200's
static route configurations.
Status/Action: Set to Active/Add.
Destination IP Address: Specifies the target network IP or
host IP. In this example we use network IP 192.168.202.0 as
the routed target.
Subnet Mask: Specifies the target network mask. In the ex-
ample, we use the subnet mask of network 192.168.202.0.
Gateway IP Address: Specifies the IP address of the next
hop router. In the example, we set this to 192.168.200.253 as
5-12
Advertisement
Table of Contents
