Trim Knife Adjustment; Adjusting For The Relaxed Position; Needle To Trim Knife; Height Of Trim Knife - AMF SERIES S104-130 Parts And Service Manual

S-104-100

TRIM KNIFE ADJUSTMENT

Adjusting for the relaxed position

The "relaxed" position is when the trim knife assembly is located over the right hand spreader stop and
away from the throat plate.
To adjust, loosen nut A and turn screw B counterclockwise or clockwise (counterclockwise will move the
trim knife assembly to the right; clockwise will move the trim knife assembly to the left) as necessary.
Once the adjustment has been made, re-tighten nut A.

Needle to Trim Knife

Lower the needle bar. The Knife should be set to pass by the needle without touching it. To adjust, loosen
screw C and move knife in or out as necessary. Once the adjustment has been made, re-tighten screw C.

Height of Trim Knife

The knife should be set so it clears the underside of the throat plate, as well as the top of the right hand
spreader stop. To adjust, loosen screw D and move up or down as necessary. Once the adjustment has
been made, re-tighten screw D.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-78
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606