T H R E A D S T A N D I N S TA L L A T I O N
1.
Put the thread stand together
according to the drawing.
2.
Position of the locking ring
assembly of the thread stand for
various thickness of the table top.
Threaded end of the post
extend more that 1 mm (1/32") through
the locking nut .
3.
Insert the washer
the hole provided in the right rear of the
table top . Insert the washer
tighten the nut .
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
THREAD STAND INSTALLATION
allows
must not
and the post into
and
S-104-100
1-5