S-104-100
To adjust the stitch count, loosen nut A and move slide link B forward or backward (forward increases the
number of stitches; backward decreases the number of stitches) as necessary. Once the adjustment has
been made, re-tighten nut A.
To increase or decrease the number of stitches in the eye portion of the buttonhole, perform the following
steps:
No eye buttonholes (Adjustable Flybar Only)
Change the selector lever, located in the rear of the bedplate, to the "NO EYE" position by moving lever
C forward to the "No Eye " position. Loosen screw D and move wedge E forward or backward (forward
increases the number of stitches, backward decreases the number of stitches.) This is done to control the
descent of roll F on the beveled portion of the wedge while the race is turning, and the buttonhole is being
sewn. Once the adjustment has been made, re-tighten screw D.
Eye Buttonholes (Adjustable Flybar Only)
Change the selector lever, located in the rear of bedplate, to the "Eye" position by moving the lever C
backward to the "Eye" position. The desired number of stitches in the eye is obtained by the position of
stop screw H. To adjust, loosen jam nut G, and move stop screw H in or out (in will increase the number
of stitches; out will decrease the number of stitches). This is done to control the descent of roll F on the
beveled portion of the wedge. Once the adjustment has been made, re-tighten jam nut G.
1-54
STITCH COUNT ADJUSTMENT
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 09/2004