Shears Cross-Over For - 170 Short Travel Cord Trim - AMF SERIES S104-130 Parts And Service Manual

S-104-100
CORD TRIM ADJUSTMENTS

Shears Cross-Over for - 170 Short Travel Cord Trim

The short travel cord trim may require the adjustment of actuator G. The adjust would be approximately
15 degree off the parallel adjustment, as described for standard cord trim on page 1-86. To adjust, loosen nut H
and rotate actuator to correct position. Once the proper position has been obtained, re-tighten nut H.
This change may be required when sewing the short buttonhole (1/2"). The shear action must be delayed
to allow the clamp arms enough time to disengage before the shearing action begins.
NOTE: Turn the left hand crank through cycle to ensure that the shears do not strike the clamp feet. DO
THIS BEFORE CYCLING THE MACHINE UNDER POWER.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-87
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606