Travel Of Looper To Center Of Needle - AMF SERIES S104-130 Parts And Service Manual

S-104-100
LOOPERS AND SPREADERS

Travel of Looper to Center of Needle

The loopers must travel to the center part of the needle. To adjust, perform the following steps:
1. Loosen screw A and rotate core B clockwise or counterclockwise slightly (rotating the core clockwise
will move looper toward the needle; rotating the core counterclockwise will move the looper away from
the needle). Once the adjustment has been made, re-tighten screw A.
NOTE: Make sure screw has been re-tightened before continuing on. If it has not been re-tightened, step
1 will have to be repeated.
2. Turn the right hand stop wheel through both needle bar strokes, stopping after the needle bar has risen
.093" or 3/32" on both strokes. Check looper to needle to ensure adjustments are correct. If the travel of
the loopers is not to the center of the needle, repeat equalizations steps on pages 1-72 and 1-73, and repeat step
1 above.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-74
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606