Flyover Lever Stop Motion - AMF SERIES S104-130 Parts And Service Manual

S-104-100
STOP MOTION ADJUSTMENTS
Ensure you use the correct stop motion procedures for your style machine.

Flyover Lever Stop Motion

When setting the stop motion the CB/CA style machines must be set in CA mode (see page 1-92).
1. Make sure the main power is OFF.
2. Turn the left hand crank until the machine is in home position. Once in the home position, turn right
hand stop wheel B until it locks in place.
3. Loosen screw M and move rocking lever N slightly to the rear. Push link C back, lever D will latch
over roller stud E. A clearance of between 0.03 and 0.07 mm (.001 and .003") must be maintained be-
tween roller F and length gauge G. To adjust, loosen lock nut H, adjust screw I up or down (up will
decrease the clearance; down will increase the clearance as necessary. Use a feeler gauge to check.
Once the adjustment has been made, re-tighten lock nut H.
4. Adjust bumper J by loosening screw K so that bumper J lightly contacts the pin of roller stud E. Once
this has been done, re-tighten screw K.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-25
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606