Adjusting Spreader Clearance - AMF SERIES S104-130 Parts And Service Manual

S-104-100
LOOPERS AND SPREADERS

Adjusting Spreader Clearance

1. Install left and right hand spreader and spreader stop.
The spreader spindle must be set to approximately 0.79 mm (0.031") above crosshead. To adjust, loosen
screw A and move the spindle up or down as necessary.
3. Set the left hand spreader stop so that the fork of the left hand spreader straddles to hole in the left hand
looper.
4. Set the right spreader stop so that the inner face of the right spreader is flush with the corresponding
inner face of the right hand looper.
5. Check the action of both spreaders to ensure that they do not bind against the top surface of the loopers
or the spreader stops.
6. Check that spreaders do not move up or down. If there is movement, move the stops down to eliminate
the movement.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-75
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606