Round Eye Stop Motion - AMF SERIES S104-130 Parts And Service Manual

S-104-100
STOP MOTION ADJUSTMENTS
Ensure you use the correct stop motion procedures for your style machine.

Round Eye Stop Motion

Home position is after the upper thread trimming action has occurred. The bedplate will travel a short
distance to the rear of the machine and stop. The race will be facing the left side of the machine.
1. Turn the left hand crank until the machine reaches home position. Turn the right hand stop wheel until
it locks.
2. Turn the left hand crank until stitch rod A reaches its highest point. Turn the right hand stop wheel until
stop dog B is at 12 o'clock. Visually check to make sure a clearance between roller C and the right hand
stop wheel is between 0.39 and 0.77 mm (.015 and .030"). To adjust, loosen clamp bolt D and move
rocking lever E forward or backward until clearance has been obtained. Once the clearance has been
obtained, re-tighten clamp bolt D.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-34
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606