Race To Needle Bar Gears; Race 180 Degree Travel - AMF SERIES S104-130 Parts And Service Manual

S-104-100
RACE ADJUSTMENTS

Race to Needle Bar Gears

With race at 90 degrees, upper vibrator block should be visually square to race. To adjust, loosen nut F,
and rotate upper sector gear G to square it off. Once this has been done, re-tighten nuts F.

Race 180 degree travel

1. Lower the machine. Turn the left hand crank until the machine is in the home position. Once at home,
continue turning the left hand crank, stopping 1/2 way along the first row of stitches.
2. Place a straight edge across the front of the race. Look at the race in relation to the straight edge - note
the distance, if any, between the two.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-40
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606