Adjusting The Clamp Plate Spread - AMF SERIES S104-130 Parts And Service Manual

S-104-100
CLAMPING

Adjusting the Clamp Plate Spread

1. Turn the left hand crank until the rollers on clamp plates A are positioned to the widest part of spreader
block G, which is located on the rear of the knife holder. Move the clamp plates side to side in order to
center them to the middle of bedplate.
2. Gently press outstop C against the side face of clamp plate A, and re-tighten screw B.
3. Repeat steps 1 and 2 for the other clamp.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-60
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606