Disengagement Of Clamp Arms - AMF SERIES S104-130 Parts And Service Manual

S-104-100
CLAMPING

Disengagement of Clamp Arms

Disengagement of the clamps is automatic when the machine is under power. If the clamps are not disen-
gaging properly, check the clearance between toggle lever A and clamp arm tip B. The clearance should
be 0.40 mm (.016"). To adjust, perform the following steps:
Turn the left hand crank until the cutting lever and the trimming action have been completed. Continue
turning the left hand crank until the bedplate stops traveling, however before it reaches the home position.
Loosen nut D, and move clamp arm C backward or forward as necessary. Once the proper clearance has
been maintained, re-tighten nut D.
NOTE: The clamp arms MUST disengage before the shearing action occurs. If they don't, repeat the
above steps.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-65
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606