Troubleshooting; Reversing Direction Of The Main Cam - AMF SERIES S104-130 Parts And Service Manual

S-104-100

TROUBLESHOOTING

Reversing Direction of the Main Cam

In the event that something becomes lodged between the main cam and the roller, the rotation of the main
cam can be reversed so the object lodged can be removed. This can be done without having to
disassemble the machine. The following procedure may be performed on both the 104-100 and 104-200
machines.
1. Remove the stitch feed located in the lower right corner of the machine by removing nut and washer A
and nut B. Remove arm C. Remove link D by removing stud E located behind cam follower F. At this
point, the slide stud located on the lower end of link D can be removed from the stitch feed housing.
2. Remove stud G located on the lower end of link H by pushing link forward, clearing stitch feed
assembly. Slide the stud out.
3. Remove snap ring I which holds the stitch feed housing onto the end of the shaft. Push link H forward,
and slide the housing off the shaft.
NOTE: DO NOT lose
washer, located behind
the snap ring, when sliding
the housing off the shaft.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
2-1
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts) ; Fax: +420 582 360 606