Stop Motion Adjustments - AMF SERIES S104-130 Parts And Service Manual

S-104-100
The majority of adjustments are started when the machine is in the home position. The home position is
reached by turning the left hand crank slowly through a cycle. Halfway through the cycle, the bedplate
will start moving towards the rear of the machine. Once the bedplate has stopped moving to the rear, it is
in home position. It is recommended that every time the machine is brought to the home position that the
right hand stop wheel be locked. This is done by turning the wheel counterclockwise.
There are two different types of stop motions: roller controlled and flyover lever. There are definite advan-
tages to the newer roller controller model:
softer, more positive stops
•
fewer adjustments
•
less down time
•
A conversion kit, P/N 03.5361.0.000, may be purchased to convert the flyover lever to roller controlled.
NOTE: Before performing the following adjustments, ensure that the needle and the left hand lower drive
belt have been removed.
Ensure you use the correct stop motion procedures for your style machine.
Roller Controlled Stop Motion
When setting this stop motion, the CB/CA style machines must be set in the CA mode (see page 1-92).
1. Make sure main power is off.
2. Turn left hand crank A until the machine is in
the home position. Once in the home position,
turn the right hand stop wheel B counterclockwise
until it locks.
1-18

STOP MOTION ADJUSTMENTS

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 09/2004