Adjustable Flybar Pins Settings - No Eye - AMF SERIES S104-130 Parts And Service Manual

S-104-100

ADJUSTABLE FLYBAR PINS SETTINGS - NO EYE

NOTE: The flybar brackets have been adjusted and pinned in the factory. If the pins are working freely,
no adjustment is necessary. If they are not working freely, perform the following steps:
1. Set the machine to the no-eye position using the eye/no-eye shifter located in the rear of the bedplate.
2. Turn the left hand crank until the race is 90 degrees to the bedplate.
3. Lift the machine. Remove springs B, loosen clamp C by loosening screw D. This will allow the clamp
to fall back.
4. Slide left flybar actuator F, to the left, repeat for the right flybar actuator F. This will free flybar pins G
so they can easily slide in and out of flybar bracket H. PINS MUST SLIDE FREELY WITHIN
BRACKET.
5. Ensure that both pins will fit into cam plate slots I freely. If they don't, adjust by loosening hex bolts,
and attaching flybar bracket H to the cam case. Remove the tapered pin located through the cam case and
flybar bracket H.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
1-43
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606