Adjusting The Clamp Operating Mechanism - AMF Reece S-101 Installation Manual

S-101
MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE
To adjust the clamp plates parallel with ledge
press the clamp plate firmly against the ledge
of the bed plate with the hand - depress the
clamp lever (101 - B 19)
the clamp plate in position. Adjust the screw
firmly against edge . Release the clamp
lever - and screw will be in adjustment.

ADJUSTING THE CLAMP OPERATING MECHANISM

1-16
. This will hold
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
To raise clamp arms for more
clearance between mats and feet -
loosen nut and screw out screw
. For less clearance screw inward.
(set check nut after adjustment)
To apply more pressure between
clamp arms and mats - loosen nut
on stud and move it upward with
screw set with nuts
to lessen pressure move stud
downward
To raise clamps sooner or later -
after cutting - on a cut after
machine - or after stitching on a
cut before machine - loosen clamp
screw and move arm
direction of arrow for earlier rise
and the reverse for later rise.
Note:
This adjustment will not raise
clamps sooner or later on cord
trim machine.
and -
in
Revised 09/2004