Machine Adjustments - Corrective And Maintenance; Needle Bar And Race Line Up Adjustment - AMF Reece S-101 Installation Manual

S-101

MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE

NEEDLE BAR AND RACE LINE UP ADJUSTMENTS
# 3
Adjustment
Vibration in line
with race
adjustments.
# 1
Adjustment
For 180 turn of race
o
# 4
Adjustment
When assembling sector mesh
the teeth on sector with race
„north - south" as in Fig. # 1
and # 4 so that sector teeth will
not disengage gear teeth at
either end of sewing
1-12
It is imperative that the race swing east - west is only 180
imperative that this 180
plate (# 2). Also the needle bar assembly must vibrate squarely "east
and west" in harmony with the race (# 3).
To proceed with these adjustments, follow this sequence:
1. Adjust stud
2. Loosen clamp screw
3. Recheck adjustment # 1 - if wrong repeat adjustment # 2 and #
1 until they are reconciled.
4. When these adjustments are correctly, adjust the needle bar
assembly "east - west" in harmony with the race by loosening
screws in sector B (# 3).
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
be square with the center line of the bed
o
to obtain adjustment # 1.
to obtain adjustment # 2.
# 2
Adjustment
For squareness of race
east and west across bed
plate.
(# 3). It is
o
Revised 09/2004