6. T H R E A D S TA N D I N S TA L L AT I O N
6.1. Put the thread stand together
according to the drawing.
6.2. Position of the locking ring
allows assembly of the thread
stand for various thickness of the
table top. Threaded end of the post
must not extend more that 1 mm
through the locking nut .
6.3. Insert the washer and the post
into the hole provided in the right
rear of the table top . Insert the
washer and tighten the nut .
Revised 04/2007
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
B
- MACHINE ASSEMBLY
Picture 6.1.
S-311
1-19