Installing and Removing a SIP
This chapter describes how to install or remove SIPs on the Cisco CRS-1 router. This chapter contains
the following sections:
•
•
•
Handling SIPs
Each SIP is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD) damage. Before
you begin installation, read
required for installation.
Always handle the SIP by the carrier edges and handle; never touch the SIP components or connector
Caution
pins (see
Figure 5-1
OL-17439-01
Handling SIPs, page 5-1
Guidelines for SIP Installation and Removal, page 5-3
SIP Installation and Removal, page 5-4
Chapter 4, "Preparing to Install a SIP or a SPA,"
Figure
5-1).
Handling a SIP
Printed circuit board
Metal carrier
GND
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
5
C H A P T E R
for a list of parts and tools
5-1