Installing Dc + Pulsed Iv Test System - Agilent Technologies B1542A User Manual

Installing DC + Pulsed IV Test System

The connection overview of the DC + pulsed IV test system is shown in Figure 2-6.
This is effective only for the system installed with the option B1542A-024. To
install the system, perform the following steps.
When you install the B1542A with the option B1542A-024, skip the steps 1 and 2.
They are not required for the installation of the B1542A with the option
B1542A-024. However they are required for the retrofit of the option B1542A-024.
1. "Assembling Gate Switch Unit (for B1542A-024 Retrofit)" on page 2-12
See this section if you retrofit the option B1542A-024. This section is not
required when you install the B1542A with the option B1542A-024.
2. "Assembling Drain Switch Unit (for B1542A-024 Retrofit)" on page 2-13
See this section if you retrofit the option B1542A-024. This section is not
required when you install the B1542A with the option B1542A-024.
3. "Connecting Switch Controller (for B1542A-024)" on page 2-14
4. "Making Measurement Path for Gate (for B1542A-024)" on page 2-15
5. "Making Measurement Path for Drain (for B1542A-024)" on page 2-16
6. "Connecting RF Probes" on page 2-17 or "Connecting DC Probes" on page 2-18
Agilent B1542A User's Guide, Edition 4
Installation
Hardware Installation
2- 11