Filename
Write Type
Read Type
Write String
Response
Figure 6-6
Remarks
Filename
Write Type
Read Type
PlsdivSetPulseWidth
This command sets the pulse width of the gate voltage.
PlsdivSetPulseWidth.exe
String
String. However, this command does not return any output parameter.
This command needs the following input parameter.
pulse_width
Pulse width of gate pulse, in second. Numeric value, 10 nsec to
1μsec. See Figure 6-6.
Status code. Numeric value. To read the error message, use PlsdivErrorMessage. If
no error is detected by this command execution, 0 is returned.
Pulse Setup Parameters
PlsdivSetSampling
This command sets the oscilloscope sampling rate and sampling number for the
pulsed IV measurement.
Adjust the sampling number and the sampling rate carefully to obtain the waveform
you desire. To obtain faster measurement throughput, decrease the sampling
number. Too small sampling numbers will cause measurement errors.
PlsdivSetSampling.exe
String
String. However, this command does not return any output parameter.
Agilent B1542A User's Guide, Edition 4
PLSDIV TIS Commands
PlsdivSetPulseWidth
6- 21