Table of Contents
Advertisement
Installation
Software Installation
Software Installation
This section describes the instructions to install the pulsed IV system software.
•
"System Requirements"
•
"Installing Software"
•
"Installing Cable Compensation Data"
•
"After Software Installation"
•
"Updating Software"
•
"If You Remove Pulsed IV Software"
To install the pulsed IV system software, perform the instructions described in
"Installing Software", "Installing Cable Compensation Data", and "After Software
Installation" in this order.
To update the pulsed IV system software, perform the instruction described in
"Updating Software".
System Requirements
The pulsed IV system software is allowed to be installed in the one of the following
system controller.
•
Agilent B1500A's internal system controller
EasyEXPERT software revision A.02.00 or later
•
Computer where Desktop EasyEXPERT software is installed
Desktop EasyEXPERT software revision A.02.00 or later
B1500A VXIplug&play driver revision A.02.00, to use B1500A
E5260A VXIplug&play driver revision A.01.00, to use E5260 series
E5270B VXIplug&play driver revision A.01.10, to use E5270B
4155/4156 VXIplug&play driver revision A.01.03, to use 4155/4156
Installation programs are stored in the B1542A-003 software CD-ROM or the
Desktop EasyEXPERT software CD-ROM. See Additionals folder for drivers.
For more information about the Desktop EasyEXPERT software, see Agilent
B1500A User's Guide.
2- 20
Agilent B1542A User's Guide, Edition 4
Advertisement
Table of Contents
