Plsdivsetadjuststat; Plsdivsetaveraging - Agilent Technologies B1542A User Manual

Response
Filename
Write Type
Read Type
Write String
Response
Filename
Write Type
Read Type
Write String
PLSDIV TIS Commands

PlsdivSetAdjustStat

If this function is off, the vd_set value will be equal to the vd value specified by the
PlsdivForceVd command and the vd_actual value will show the value divided by
the shunt resistor.
Status code. Numeric value. To read the error message, use PlsdivErrorMessage. If
no error is detected by this command execution, 0 is returned.
PlsdivSetAdjustStat
This command enables or disables the automatic output adjustment of the specified
source, PGU (pulse generator) for the gate voltage or SMU (source monitor unit) for
the drain voltage.
PlsdivSetAdjustStat.exe
String
String. However, this command does not return any output parameter.
This command needs the following input parameters in this sequence.
term Terminal. Numeric value, 0 (gate) or 1 (drain).
adj_stat Function status. Numeric value, 0 (off) or 1 (on).
Status code. Numeric value. To read the error message, use PlsdivErrorMessage. If
no error is detected by this command execution, 0 is returned.

PlsdivSetAveraging

This command sets the oscilloscope averaging number for the pulsed IV
measurement. Large averaging number contributes high certainty of measurement
result and long measurement time.
PlsdivSetAveraging.exe
String
String. However, this command does not return any output parameter.
This command needs the following input parameter.
avg_num Averaging number. Numeric value, 1 to 4096.
6- 18 Agilent B1542A User's Guide, Edition 4