Plsdiv Dc Idvg - Agilent Technologies B1542A User Manual

Device Parameters The following parameters are available to set the test condition.
Test Parameters
PLSDIV Test Definitions

PLSDIV DC IdVg

PLSDIV DC IdVg
This test definition controls SMUs to force the drain voltage and the gate voltage,
measures the drain current, and displays the Id-Vg characteristics.
Polarity Polarity of source output. Nch (force the specified value) or Pch
(force the negative specified value).
Gate length, in m. ≥ 1 nm, 4 digits or 1 nm resolution.
Lg
Gate width, in m. ≥ 1 nm, 4 digits or 1 nm resolution.
Wg
Temp Temperature, in degree. 4 digits or 0.001 degree resolution.
IdMax Maximum drain current measurement range, in A. 0 to 80 mA,
4 digits or 1 μA resolution.
The following parameters are available to set the source output.
CableR Residual resistance of the gate measurement path from SMU to
terminator. ≥ 0 Ω, 4 digits or 1 mΩ resolution.
Resistance of terminator. ≥ 1 mΩ, 4 digits or 1 mΩ resolution.
TermR
TermR=No applies 1E+30 Ω.
Gate SMU connected to the gate terminal.
VgStart Primary sweep start voltage for the gate terminal. -10 to 10 V,
4 digits or 10 mV resolution.
VgStop Primary sweep stop voltage for the gate terminal. -10 to 10 V,
4 digits or 10 mV resolution.
VgStep Primary sweep step voltage for the gate terminal. -10 to 10 V,
5 digits or 1 mV resolution.
Drain SMU connected to the drain terminal.
VdStart Secondary sweep start voltage for the drain terminal. -10 to 10
V, 4 digits or 10 mV resolution.
VdStop Secondary sweep stop voltage for the drain terminal. -10 to 10
V, 4 digits or 10 mV resolution.
VdStep Secondary sweep step voltage for the drain terminal. -10 to 10
V, 5 digits or 1 mV resolution.
5- 12 Agilent B1542A User's Guide, Edition 4