Changing The Default Cisco Rv110W Ip Address - Cisco RV110W Administration Manual

Configuring Networking
Configuring the LAN Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV110W Administration Guide

Changing the Default Cisco RV110W IP Address

To configure the default LAN IP address of the Cisco RV110W:
Choose Networking > LAN > LAN Configuration.
In the IPv4 section, enter this information:
VLAN
Local IP Address
Subnet mask
Click Save.
After changing the Cisco RV110W LAN IP address, your PC is no longer
connected to the Cisco RV110W.
To reconnect your PC to the Cisco RV110W, do one of the following:
• If DHCP is configured on the Cisco RV110W, release and renew your PC IP
address.
• Manually assign an IP address to your PC. The address must be on the same
subnet as the Cisco RV110W. For example, if you change the Cisco RV110W
IP address to 10.0.0. 1 , assign your PC an IP address in the range of 10.0.0.2
to 10.0.0.255.
Open a new browser window and enter the new IP address of the Cisco RV110W
to reconnect.
Choose the VLAN number from the drop-down
menu.
Enter the LAN IP address of the Cisco RV110W.
Make sure the address is not in use by another
device.
Choose the subnet mask for the new IP address
from the drop-down menu. The default subnet is
255.255.255.0.
2
30