Configuring Vlans - Cisco RV110W Administration Manual

Configuring Networking
Configuring the LAN Settings
STEP 4
STEP 5
STEP 6
Cisco RV110W Administration Guide
If you selected Enable, enter this information:
Starting IP Address
Maximum Number of
DHCP Users
IP Address Range
Client Lease time
Static DNS 1
Static DNS 2
Static DNS 3
WINS
If you selected DHCP Relay, enter the address of the relay gateway in the Remote
DHCP Server field. The relay gateway transmits DHCP messages between
multiple subnets.
Click Save.

Configuring VLANs

A Virtual LAN (VLAN) is a group of endpoints in a network that are associated by
function or other shared characteristics. Unlike LANs, which are usually
geographically based, VLANs can group endpoints without regard to the physical
location of the equipment or users.
The Cisco RV110W has a default VLAN (VLAN 1), which cannot be edited or
changed. You can create four other VLANs on the Cisco RV110W.
Enter the first address in the IP address pool. Any
new DHCP client joining the LAN is assigned an IP
address in this range (the ending IP address in the
pool is determined by the value you enter in the
Maximum Number of DHCP Users field).
Enter the maximum number of DHCP clients.
(Read-only) Displays the range of IP addresses
available to the DHCP clients.
Enter the duration (in hours) for which IP addresses
are leased to clients.
Enter the IP address of the primary DNS server.
Enter the IP address of the secondary DNS server.
Enter the IP address of the tertiary DNS server.
Enter the IP address of the primary WINS server.
2
32