(Optional) Change The Ip Address; (Optional) Log Into The Firepower Chassis Manager - Cisco Firepower 2100 Series Getting Started Manual

(Optional) Change the IP Address

(Optional) Change the IP Address
If you cannot use the default IP address for ASDM access, you can set the IP address at the ASA CLI.
Note This procedure restores the default configuration and also sets your chosen IP address, so if you made any
changes to the ASA configuration that you want to preserve, do not use this procedure.
Procedure
Step 1
Step 2
Step 3

(Optional) Log Into the Firepower Chassis Manager

Use the Firepower Chassis Manager to configure chassis settings, including enabling interfaces and creating
EtherChannels.
Before you begin
• For information on supported browsers, refer to the release notes for the version you are using (see
• If you need to change the FXOS and ASA management IP addresses, see
Procedure
Step 1
On your management computer connected to the Management 1/1 interface, launch the Firepower Chassis
Manager by going to the following URL.
https://192.168.45.45
Cisco Firepower 2100 Getting Started Guide
80
Command or Action
Connect to the ASA console port, and enter
global configuration mode. See
and FXOS CLI, on page 91
information.
Restore the default configuration with your
chosen IP address.
Example:
ciscoasa(config)# configure
factory-default 10.1.1.1 255.255.255.0
Save the default configuration to flash memory.
http://www.cisco.com/c/en/us/support/security/firepower-9000-series/products-release-notes-list.html).
Management IP Addresses or Gateway, on page
Purpose
Access the ASA
for more
configure factory-default [ip_address [mask]]
Note
write memory
93.
ASA Deployment in Platform Mode
This command does not clear the
currently-set mode, Appliance or
Platform, for the Firepower 2100.
(Optional) Change the FXOS