Cisco RV110W Administration Manual page 46

Configuring Networking
Configuring IPv6
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco RV110W Administration Guide
Configuring DHCPv6
If your ISP provides you with a dynamically-assigned address, configure the
Cisco RV110W to use be a DHCPv6 client.
To configure the Cisco RV110W to be a DHCPv6 client:
Choose Networking > IPv6 > IPv6 WAN Configuration.
In the WAN Connection Type field, select Automatic Configuration-DHCPv6.
Click Save.
Configuring a Static WAN IP Address
If your ISP assigns you a fixed address to access the Internet, configure the
Cisco RV110W to use a static IPv6 address.
To configure the Cisco RV110W to use a static IPv6 address:
Choose Networking > IPv6 > IPv6 WAN Configuration.
In the WAN Connection Type field, select Static IPv6.
Enter this information:
IPv6 Address
IPv6 Prefix Length
Default IPv6 Gateway
Enter the IPv6 address of the WAN port.
Enter the IPv6 prefix length defined by the ISP.
The IPv6 network (subnet) is identified by the initial
bits of the address which are called the prefix.
For example, in the 2001:0DB8:AC10:FE01::
IP address, 2001 is the prefix.
All hosts in the network have identical initial bits for
their IPv6 address; you set the number of common
initial bits in the network addresses in this field.
Enter the IPv6 address of the default gateway. This
is the IP address of the server at the ISP that this
router connects to for accessing the Internet.
2
46