Cisco RV110W Administration Manual page 47

Configuring Networking
Configuring IPv6
STEP 4
STEP 1
STEP 2
STEP 3
Cisco RV110W Administration Guide
Static DNS 1
Static DNS 2
Click Save.
Configuring PPPoE IPv6 Settings
If you choose this option, your IPv6 WAN PPPoE settings must match your IPv4
WAN PPPoE settings. See
To configure the Cisco RV110W PPPoE IPv6 settings:
Choose Networking > IPv6 > IPv6 WAN Configuration.
In the WAN Connection Type field, choose PPPoE IPv6.
Enter the following information (you may need to contact your ISP to obtain your
PPPoE login information):
Username
Password
Connect on Demand
Keep alive
Enter the IP address of the primary DNS server on
the ISP IPv6 network.
Enter the IP address of the secondary DNS server
on the ISP IPv6 network.
Configuring PPPoE.
Enter your username assigned to you by the ISP.
Enter your password assigned to you by the ISP.
Select this option if your ISP charges based on the
amount of time that you are connected. When you
select this option, the Internet connection is on only
when traffic is present. If the connection is idle—
that is, no traffic is flowing—the connection is
closed. If you click Connect on Demand, enter the
number of minutes after which the connection
shuts off in the Max Idle Time field.
When you select this option, the Internet
connection is always on. In the redial period field,
enter the number of seconds after which the
Cisco RV110W attempts to reconnect if it is
disconnected.
2
47