Connecting To Your Wireless Network - Cisco RV110W Administration Manual

Introduction

Connecting to Your Wireless Network

Connecting to Your Wireless Network
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV110W Administration Guide
To connect a device (such as a computer) to your wireless network, configure the
wireless connection on the device with the wireless security information you
configured for the Cisco RV110W by using the Setup Wizard.
The following steps are provided as an example; you may need to configure your
device differently. For instructions that are specific to your device, consult its
documentation.
Open the wireless connection settings window or program for your device.
Your computer may have special software installed to manage wireless
connections, or you may find wireless connections under the Control Panel in the
Network Connections or Network and Internet window. (The location depends
on your operating system.)
Enter the network name (SSID) you chose for your network in the Setup Wizard.
Choose the type of encryption and enter the security key that you specified in the
Setup Wizard.
If you did not enable security (not recommended), leave the wireless encryption
fields that were configured with the security type and passphrase blank.
Verify your wireless connection and save your settings.
1
21