Configuring The Lan Settings - Cisco RV110W Administration Manual

Configuring Networking

Configuring the LAN Settings

STEP 2
Configuring the LAN Settings
NOTE
Cisco RV110W Administration Guide
MTU
Size
Click Save.
The default DHCP and TCP/IP settings work for most applications. If you want
another PC on your network to be the DHCP server, or if you want to manually
configure the network settings of all of your PCs, disable DHCP.
Also, instead of using a DNS server, which maps Internet domain names (for
example, www.cisco.com) to IP addresses, you can use a Windows Internet
Naming Service (WINS) server. A WINS server is the equivalent of a DNS server
but uses the NetBIOS protocol to resolve hostnames. The Cisco RV110W includes
the IP address of the WINS server in the DHCP configuration the Cisco RV110W
sends to DHCP clients.
If the Cisco RV110W is connected to a modem or device that has a configured
network on the same subnet (192. 1 68. 1 .x), the Cisco RV110W automatically
changes the LAN subnet to a random subnet based on 10.x.x.x, so there is no
conflict with the subnet on the WAN side of the Cisco RV110W.
You can assign an IP address to each additional subnet on the Cisco RV110W.
The Maximum Transmit Unit (MTU) is the size of the
largest packet that can be sent over the network.
The standard MTU value for Ethernet networks is
usually 1500 bytes. For PPPoE connections, the
value is 1492 bytes.
Unless a change is required by your ISP, Cisco
recommends that you choose Auto. The default
MTU size is 1500 bytes.
If your ISP requires a custom MTU setting, choose
Manual and enter the MTU size.
Enter the MTU size.
2
29