Cisco RV110W Administration Manual page 53

Configuring Networking
Configuring IPv6
STEP 3
STEP 4
Cisco RV110W Administration Guide
Enter this information:
Name
Destination
Prefix Length
Gateway
Interface
Metric
Active
Click Save.
To edit the settings of a route, select the route and click Edit. To delete a selected
route, click Delete. Click Save to apply changes.
Enter the route name.
Enter the IPv6 address of the destination host or
network for this route.
Enter the number of prefix bits in the IPv6 address
that define the destination subnet.
Enter the IPv6 address of the gateway through
which the destination host or network can be
reached.
Choose the interface for the route from the
drop-down menu: LAN, WAN, or 6to4.
Enter the priority of the route by choosing a value
between 2 and 15. If multiple routes to the same
destination exist, the route with the lowest metric is
used.
Check to make the route active.
When you add a route in an inactive state, it gets
listed in the routing table, but is not used by the
Cisco RV110W. You can always activate the route
later.
This feature is useful if the network that the route
connects to is not available when you added the
route. When the network becomes available, you
can enable the route.
2
53