Main Output Bus Set-Up - Sony OXFORD Operation Manual

4-12 Mixing to the Main Output Bus

4-12-1 Main Output Bus Set-up

2
3
4-24
Chapter 4 Signal Paths
1 4
MULTI-FORMAT & STEREO SUB-GROUPS 1-16
L L/C
SET SET
LOCK
MAIN MT
WIDTH STEMS
L-S
5, 8
Master Section set-up functions
The 8 character dot display to the left of this panel can display the format
for the Main Output Bus and that of M/T Stems.
If the {SET MAIN WIDTH} button is lit, the format for the Main Output Bus
is displayed: STEREO, LCRS, 5.1 or 7.1. The current format for the Main
Output Bus is also displayed in the 8 character display above the central
Master fader.
If the {SET MT STEMS} button is lit, the format for the M/T Bus is
displayed: STEREO, LCRS, 5.1 or 7.1.
1
The {LOCK} push-button is normally lit, indicating that the set-up is
locked. Press to unlock indicated by the light going off. This button
will time out back to lock status 10 seconds after the last button push.
Note
A Config. Set-up option enables the {LOCK} button as a level of security, i.e. it
must be unlocked to allow bus assignment set-up.
7
CAL
C R/C R
MONO
DIM
CUT
SUB R-S
MIX
M-F MON
BUS
EXT
EXT EXT
1 2 3
EXT EXT EXT
5
4 6