Table of Contents
Advertisement
Once the Stem Masters have been set up on channels make sure the central
Master Fader is set to maximum, 0dB. Then the monitor signal is
available via the centre section controls as follows:
Note
What follows is an overview of the Monitor functions. For detailed descriptions of
individual functions, see Chapter 6.
1 LS1 Push-Button
Selects the primary set of Monitor LS and is the fire-up default. Make sure
the {LS 1} button is lit, or press it if not.
2 CR Monitor Level
Sets the level to the Control Room LS and operates in tandem with the
Surround Level 9, on the upper panel illustrated on the page opposite.
3 DIM Push-Buttons
Dims the CR Monitor LS according to the Dim setting, adjusted using the
small definable knob situated above 2.
4 CUT Push-Buttons
Cuts all the CR Monitor LS simultaneously.
Note
Note
{DIM} and {CUT} are situated in both panel sections and work in tandem.
5 CUT L – CUT R-S Push-Buttons
Individual CR Monitor LS mutes.
6 Surround Fold-Down Matrix
The monitor signal fire-up default is the Main Output Bus. It is possible to
listen to a folded down version of the Main Output Bus as follows:
• Select FOLDDOWN as the source in one of the EXT SOURCE windows
using the { + } and { – } buttons either side of their 8 character dot display.
• Press to light the {SELECT} button to the right of that Source Selector.
• Select folded down versions of the Main Output Bus as desired and note
that only sources of the same width or less than that of the Main Bus
format are valid.
7 CAL Push-Button
Toggles between a fixed calibrated setting and the variable setting of the
knob 9.
8 8 Character Dot Display
Indicates the level in dB SPL, provided the system has been calibrated
correctly. The Calibration Procedure is described in Appendix A-3.
9 Level Knob
Adjusts the levels for all LS simultaneously when {CAL} is not lit. To
change the CAL setting, push, hold and adjust accordingly, then release.
4-39
Chapter 4 Signal Paths
Advertisement
Table of Contents
