Table of Contents
Advertisement
7-11 Preferences
7-102
Chapter 7 Session Management
SESSION Tab
AUTOSAVE INTERVAL
• Sets the interval, from 1 to 60 minutes, between Autosaves of the
working mix. Saves will occur only if there is new data which has not
been saved.
AUTOSAVE ENABLE
• Allows Autosave to be turned on or off.
AUTOSAVE STATIC CHANGES
• Allows Autosave to be triggered to Autosave static non-automated
changes.
CANCEL KEY CANCELS CYCLES
• Allows the system to be set so that {CANCEL} on the Control Keyboard
cancels machine cycle commands.
Note:
The following LOCK Preferences refer to the {LOCK} push-button on the Monitor
panel in the centre section. When {LOCK} is on, a number of functions can be
locked out of operation. These are useful safety settings in live and broadcast
situations where the loading of Automation and/or Snapshot data could overwrite
a critical console set-up.
LOCK DISABLES FULL LOAD
• Disables the Loading of Full console-wide Snapshots and Mixes.
LOCK DISABLES PARTIAL LOADS
• Disables the Loading of Partial Snapshots and Mixes which would affect
less than the full console.
LOCK DISABLES COPIES
• Disables the Copying of settings from a source channel to one or more
other channels.
LOCK DISABLES NEW LINKS
• Disables the channel Link set-up mechanism but leaves channels already
linked intact.
LOCK DISABLES MAKE STATIC
• Disables the {MAKE STATIC} key on the Control Keyboard which
normally removes automation from the working mix.
LOCK DISABLES OFFLINE OPS
• Disables all Offline operations whether GUI or keyboard entry.
VPANEL ENABLE
• Enables transport control via GPIO from an external panel or virtual
panel.
Advertisement
Table of Contents
