Table of Contents
Advertisement
7-7 Dynamic Automation Moves
7-7 Dynamic Automation Moves
7-7-1 Motorised Fader Controls
1 Touch-sensitive fader knob
When dynamically automated moves are replaying,
touching the fader knob inhibits the electronic servo
control. Control of the audio level depends on the
system mode at the time.
2 Automation Write button
The small tactile button in the fader knob allows single
finger operation when dropping in to write moves in
absolute or trim. Whilst the fader is moving, take
control of the fader with one finger and - at the
appropriate time - press the Write button with the same
finger.
Note
The Ready ABS or TRM button must be selected to record
moves, indicated by their LEDs flashing.
3 Yellow Touch LED
This LED lights when the system detects that a finger
is touching the fader.
4 Ready ABS (Absolute) Write button
Pressing the ABS button puts the fader into the 'ready
absolute' status. If the Automation Write button in the
fader knob is then pressed, automation data will be
written.
5 Red Absolute LED
This LED indicates the Absolute write record status of
the fader. Flashing indicates a record ready status and
fully lit means that move data is being recorded.
6 Ready TRM (Trim) button
Pressing the TRM button puts the fader into the 'ready
trim' status. The TRM and ABS buttons inter-cancel.
7 Green Trim LED
This LED indicates the Trim write record status of the
fader. Flashing indicates a record ready state and fully
lit means that any trimming move data will be
recorded.
8 Bi-colour fader CUT switch
This switch illuminates red when the cut is
implemented manually, and amber if the cut is
controlled by the automation system. It is lit extra
bright and amber if manual and automated cuts are
performed simultaneously.
7-64
Chapter 7 Session Management
3
SOLO
CUT
5
4
ABS
TRM
10
10
5
5
0
0
5
5
10
10
20
20
30
30
40
40
1
60
60
∞
∞
Motorised Fader controls
8
7
6
2
Advertisement
Table of Contents
