Table of Contents
Advertisement
QUICK LINK
This is accomplished using the lower row of
ACCESS buttons, as follows:
• Press and hold down the lower {ACCESS} button
for the source channel.
• Its {ACCESS} will light, first red and then turn
amber after half a second.
• When it has changed to amber, select the lower
ACCESS buttons for the destination channels, one
by one.
In this case, controls are linked and any offsets
between knob settings are retained.
Note
The retention of offsets applies only to those knobs
which can be fully automated.
The control settings linked in 'Quick Link' are set
according to what is highlighted in the Link
DEFAULTS field displayed on the LINK page. Click
on LINK in the banner at the top of the GUI to view
the LINK DEFAULTS.
Note
Make sure LINK DEFAULTS is highlighted in red in
the LINK page. Click on it if not.
QUICK COPY and LINK
This is accomplished using the upper and lower rows
of ACCESS buttons, as follows:
• Press and hold down the lower {ACCESS} button
for the source channel.
• Its {ACCESS} will light, first red and then turn
amber after half a second.
• When it has changed to amber, select the upper
ACCESS buttons for the destination channels, one
by one.
The control settings linked in 'Quick Copy and Link'
are set according to what is highlighted in the Link
DEFAULTS field displayed on the LINK page. Click
on LINK in the banner at the top of the GUI to view
the LINK DEFAULTS.
Note
Make sure LINK DEFAULTS is highlighted in red in
the LINK page. Click on it if not.
Chapter 7 Session Management
7-55
Advertisement
Table of Contents
