Table of Contents
Advertisement
PAN OUT RESET
• RESET
- Switching a Pan out will centre it if switched in again.
• RESTORE
- Switching a Pan out will centre it, but it will return to
its previous setting if switched in again.
ST METER
This option applies to the central stereo meter when
under the "METERS" heading at the top right of the Monitor panel.
- Central stereo meter displays the L and R signals from
• MAIN
the Main Output Bus.
• FDOWN
- Central stereo meter displays the L and R signals
derived in the Fold-Down Matrix.
LS3
This option applies to the stereo CR Monitor LS3, when
under the "MONITOR LS" heading at the middle right of the Monitor
panel.
• MAIN
- The LS3 feed is the L and R signals from the Main
Output Bus.
- The LS3 feed is the L and R signals derived in the
• FDOWN
Fold-Down Matrix.
OSC A & OSC B
Oscillators outputs A & B are controlled by clicking on
right of the parameter displays.
• Level: dBs
- -100, -90, -80, -70, -60, -50, -40, -30 – 0dB in 1dB
steps.
• Frequency: Hz - 20, 30, 40, 50, 60, 70, 80, 90, 100, 200, 300, 400, 500,
600, 700, 800, 900.
kHz - 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 12, 14, 16, and 20.
The Softkeys for this GUI:
• TOP
- Selects the top level LOGO screen
• IO ALIAS
- Alias naming facility for all types of I/O
• DIALOG
- Naming facility for all I/O Scribble pop-ups
• FIO MONO
- Set-up facility for Fast Insert I/O
• SRC
- Sample Rate Converter control
{MAIN} is selected
{MAIN} is selected
4 and $ to the
5-33
Chapter 5 Control Screens
Advertisement
Table of Contents
