Table of Contents
Advertisement
1
2
3
OSCILLATOR Section
The Sine Wave oscillator source frequency and level are controlled from
the definable knob above the CR Monitor level knob. The frequency is
variable from 20Hz to 20kHz and the level is variable between -70dB and
0dB (digital full scale) in 1dB increments. The default Oscillator output is
0dB @ 1kHz. The push-button controls on the Monitor Panel function as
follows:
1 ON Push-Button
Switches the oscillator on, which also automatically sets monitor DIM on.
(It can be switched off again if required). TONE buttons in SSGs and
Sends sections are inoperative unless the Oscillator ON is selected.
2 TO MAIN Push-Button
Replaces the Main Output Bus signal with the oscillator signal. The
Oscillator ON button must be selected. The CR Monitor LS dim
automatically.
3 TO GROUPS Push-Button
Sends the Oscillator output to all multitrack Group outputs replacing bus
signals. The Oscillator ON must be selected.
6-61
Chapter 6 Technical Descriptions
Advertisement
Table of Contents
