Probes And Accessories - Agilent Technologies InfiniiVision 4000 X-Series User Manual

22
Reference
Pollution Degree
Definitions

Probes and Accessories

This section lists the probes and accessories that are compatible with the
4000 X- Series oscilloscopes.
•
•
•
•
•
AutoProbe
Most Agilent single- ended active, differential, and current probes are
Interface
compatible with the AutoProbe interface. Active probes that do not have
their own external power supply require substantial power from the
AutoProbe interface.
In the following tables, for AutoProbe interface compatible probes,
"Quantity Supported" indicates the maximum number of each type of
active probe that can be connected to the oscilloscope.
If too much current is drawn from the AutoProbe interface, an error
message will be displayed, indicating that you must momentarily
disconnect all probes to reset the AutoProbe interface, then connect only
the supported quantity of active probes.
See Also
For more information on probes and accessories, see
for:
•
•
368
Pollution Degree 1: No pollution or only dry, non-conductive pollution occurs.
The pollution has no influence. Example: A clean room or climate controlled
office environment.
Pollution Degree 2. Normally only dry non-conductive pollution occurs.
Occasionally a temporary conductivity caused by condensation may occur.
Example: General indoor environment.
Pollution Degree 3: Conductive pollution occurs, or dry, non-conductive
pollution occurs which becomes conductive due to condensation which is
expected. Example: Sheltered outdoor environment.
"Passive Probes" on page 369
"Single- Ended Active Probes"
"Differential Probes"
"Current Probes" on page 371
"Accessories Available"
"Probes and Accessories Selection Guide (5989- 6162EN)"
"InfiniiVision Oscilloscope Probes and Accessories Selection Guide Data
Sheet (5968- 8153EN)"
on page 369
on page 370
on page 371
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
"www.agilent.com"