14
Measurements
Measurement
"AC RMS"
"Top"
"+ Width"
"– Width"
"X at Max Y"
"X at Min Y"
*
Power App
Note that additional Power App measurements are available when the
Measurements
DSOX4PWR power measurement and analysis license is installed and the
Power Application is enabled. For more information, see the DSOX4PWR
Power Measurement Application User's Guide at
"www.agilent.com/find/4000X- Series- manual"
Dual-Channel
Note that additional measurements are available with the N2820A
(N2820A Probe)
high- sensitivity current probe when both the Primary and Secondary
Measurements
probe cables are used. Zoom In waveform data below the probe's clamp
level is joined with Zoom Out waveform data above the probe's clamp level
to create the waveform on which the measurement is made. These
measurements are only valid for analog input channels.
Dual-Channel (N2820A Probe)
Measurement
Amplitude
Charge
Average
Base
Peak-Peak
244
on page 252
on page 248
on page 257
on page 257
on page 261
on page 261
Use the cursors to make other measurements on FFT.
Valid
Valid for
for
Digital
Math
Channels
*
FFT
Yes
Yes
Yes
Yes
Notes
See
"Amplitude"
Charge (in Amp-hours) is the measured area under
the waveform. See
See
"Average"
See
"Base"
See
"Peak-Peak"
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
Notes
The resultant units are in Hertz.
The resultant units are in Hertz.
or on the Documentation CD.
on page 247.
"Area"
on page 263.
on page 251.
on page 249.
on page 247.