To Select Generated Waveform Types And Settings; 18, "Save/Email/Recall (Setups, Screens - Agilent Technologies InfiniiVision 4000 X-Series User Manual

A waveform generator is built into the oscilloscope. It is enabled by
Option WGN or the DSOX4WAVEGEN2 upgrade. The waveform generator
gives you an easy way to provide input signals when testing circuitry with
the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope
setups. See
starting on page 307.

To select generated waveform types and settings

1 To access the Waveform Generator Menu and enable or disable the
Agilent InfiniiVision 4000 X-Series Oscilloscopes
User's Guide
17
Waveform Generator
To select generated waveform types and settings
To edit arbitrary waveforms
To output the waveform generator sync pulse
To specify the expected output load
To use waveform generator logic presets
To add noise to the waveform generator output
To add modulation to the waveform generator output
To restore waveform generator defaults
To set up dual channel tracking
Chapter 18, "Save/Email/Recall (Setups, Screens, Data),"
waveform generator output on the front panel Gen Out BNC, press the
[Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is
illuminated. When waveform generator output is disabled, the [Wave
Gen] key is off.
289
305
s1
285
297
298
298
299
300
305
285