Waveform Generator - Agilent Technologies InfiniiVision 4000 X-Series User Manual

17

Waveform Generator

Waveform Characteristics
Type
Exponential Use the Frequency/Frequency
Rise Fine/Period/Period Fine, Amplitude/High-Level,
and Offset/Low-Level softkeys to set the
exponential rise signal parameters.
Exponential Use the Frequency/Frequency
Fall Fine/Period/Period Fine, Amplitude/High-Level,
and Offset/Low-Level softkeys to set the
exponential fall signal parameters.
Cardiac Use the Frequency/Frequency
Fine/Period/Period Fine, Amplitude, and Offset
softkeys to set the cardiac signal parameters.
Gaussian Use the Frequency/Frequency
Pulse Fine/Period/Period Fine, Amplitude, and Offset
softkeys to set the Gaussian pulse signal
parameters.
1
When the output load is 50 , these values are halved.
2
The minimum amplitude is limited to 40 mVpp if the offset is greater than 500 mV or less than -500 mV. Likewise, the offset
is limited to +/-500 mV if the amplitude is less than 40 mVpp.
The Settings softkey opens the Waveform Generator Settings Menu which
lets you make other settings related to the waveform generator.
288
Pressing a signal parameter softkey can open a menu for selecting the
type of adjustment. For example, you can choose to enter amplitude
and offset values, or you can choose to enter high- level and low- level
values. Or, you can choose to enter frequency values or period values.
Keep pressing the softkey to select the type of adjustment. Turn the
Entry knob to adjust the value.
Also note that you can set up the other waveform generator output to
track frequency, amplitude, offset, and duty cycle adjustments. See
set up dual channel tracking"
Frequency
Range
100 mHz to
5 MHz
100 mHz to
5 MHz
100 mHz to
200 kHz
100 mHz to
5 MHz
on page 305.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
2
Max. Offset
2
Amplitude (High-Z)
?1
(High-Z)
20 mVpp to ±5.00 V
10 Vpp
20 mVpp to ±5.00 V
10 Vpp
20 mVpp to ±2.50 V
9 Vpp
20 mVpp to ±2.50 V
7.5 Vpp
1
"To